Rev C
Instructions
Procedure - S
®
and Z® Booms
Part No. 1295251GT
Lift Connect
™
17
7 Connect the loose end of the retrofit harness
to the 8 pin connector located on the back of
the control box.
1 telematics module
2 connector, 8 pin
8 Turn the key switch to ground control and pull
out the red Emergency Stop button to the on
position.
Result: The LED is blinking on the retrofit
harness. The retrofit harness is working
properly.
Result: The LED is on solid. Check harness
connections or replace the retrofit harness.
9 Turn the key switch to the off position and
push in the red Emergency Stop button to the
off position at the ground controls.
10 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
11 Push the control box towards the machine and
secure it with the control box latch.
12 Locate the machine serial label.
13 Using a mild cleaning solvent, clean an area
next to the serial label. Adhere one of the
provided ESN decals to the machine.
Note: The ESN decals are provided with the
telematics module.
14 Adhere the lexan cover decal over the ESN
decal.
Genie part number 1291624GT.
Updating the Machine Software
Note: The Plus+1 Service Tool must be
installed on your computer.
1 Go to the Genie Firmware site. From the drop
down
menu under
Machine Model
, select the
model that is appropriate for your machine.
Select
Search
.
2 Under
Application Firmware
, open the
.zip
file and save the
.lhx
file for
Controller Type
PCON
and
TCON
to your desktop.
3 Update the machine software.
4 After the software is updated, navigate to the
Options menu on the machine and verify that
Lift Connect (Telematics) is enabled.
Register and activate the telematics
module. Refer to page 7.
