Instructions
Rev C
GS
™
Models
46
Lift Connect
™
Part No. 1295251GT
5 Install the provided trim lock in the corner of
the ground controls compartment.
Genie part number 46718GT.
1 ground control panel
2 retaining fasteners
3 trim lock
4 telematics module
6 Route the telematics module harness into the
ground controls compartment next to the trim
lock.
7 Remove the retaining fasteners securing the
ground control panel and set aside.
8 Open the ground control panel and locate the
8 pin connector inside the ground control box.
9 Connect the retrofit harness to the 8 pin
connector.
Genie part number 1293896GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
10 Route the loose end of the retrofit harness out
of the control box with the existing harnesses.
Note: The access hole is located in the back, left
side of the control box.
11 Connect the telematics module to the retrofit
harness.
12 Secure the harness to the existing cables
using the provided cable ties.
Genie part number 21121GT.
13 Close the ground control panel.