Rev C
Instructions
GTH
™
Models
Part No. 1295251GT
Lift Connect
™
51
8 Connect the wiring adapter harness to the 8
pin connector located at the bottom of the cab
behind the steering column.
Genie part number 55.0602.1184GT.
Note: Harness connectors are keyed for proper
installation.
Component damage hazard.
Improper connections will result
in damage to the telematics
module and it is not covered
under warranty.
example of keyed harness connector
1 telematics module
2 connector, 8 pin
9 Connect the telematics module to the wiring
adapter harness.
10 Using a small flathead screwdriver, remove
the instrument panel from the instrument
dashboard and set aside.
1 instrument panel
2 fuse panel compartment
11 Open the fuse panel compartment. Remove
the plastic fuse cover and set aside.
12 Route the loose end of the wiring adapter
harness with the ring terminal through the
instrument dashboard and into the fuse panel.
Note: The access hole into the fuse panel
compartment is located in the left front bottom
corner.
13 Connect the ring terminal to the location
shown below on the fuse panel.
