Tandberg Data Storage Library T128, Руководство пользователя

Страница: 98 / 192

86 Installing, Removing, and Replacing
3 Connect the module-to-module cables.
a. Using the module terminators, terminate the top and bottom modules in the library stack. Install
one module terminator in the top terminator connector on the topmost module and one in the
bottom terminator connector on the bottommost module.
If your library configuration consists of a single module, place module terminators in the
module’s top and bottom module terminator connector.
b. If you need to add a 9U expansion module to the control module, remove the module terminator
from the control module terminator connection that is closest to the 9U expansion module.
c. Replace the module terminator in the 9U expansion module in the terminator connection that is
furthest from the control module.
d. Connect the module-to-module cable from the control module to the 9U expansion module.
4 Connect your Ethernet cable to the Gigabit (GB) Ethernet port on the library control blade (LCB) for
remote access to the library via the web client.
5 Connect a power cord to the outlet on the power supply on the rear of the library.
There should always be a power cord connected to the power supply on the control module. If
redundant power supplies are used, connect a power cord to each of the additional power supply
outlets.
6 Power on the library.
a. Turn on the rear power switch of each of the power supplies.
b. Turn on the front power switch.
c. Power up the host system.
7 Verify communication with all devices on the bus.
8 Configure the library using the commands on the operator panel. See configuration information in
Configuring Your Library on page 29.
CAUTION
The module terminator is not the same as a SCSI terminator. Using a
SCSI terminator instead of a module terminator will damage the
library.