Tandberg Data Storage Library T128, Руководство пользователя

Страница: 125 / 192

Tandberg StorageLibrary T128 User’s Guide 113
a. From the front of the library, open the I/E station and access doors of the 9U expansion module.
Squeeze the handle of the Y-rail release mechanism, lift it out of its locked position, and slide
it downward as far as it will go.
b. From the back of the library, find the rear Y-rail release mechanism, which is located in the
interior of the right side of the module. Squeeze the handle of the Y-rail release mechanism, lift
it out of its locked position, and slide it downward as far as it will go.
Doing this aligns the Y-rails with the Y-rails of the module beneath it.
2 Add the tape drives to the modules. For details, see Adding, Removing, and Replacing Tape Drives on
page 148.
3 Add the power supplies. For details, see Adding, Removing, and Replacing Power Supplies on page
136.
4 Add the LCB to the control module. For details, see Removing and Replacing the Library Control Blade
and LCB Compact Flash Card on page 133.
5 Unpark the robot assembly.
a. Gently raise the robot assembly so that it no longer rests on the parking tab.
CAUTION
Check to make sure that there is no gap between the top and bottom
Y-rails on both the front and back of the library. If a gap exists, the
library cannot mechanically initialize.
CAUTION
Support the robot assembly by holding onto the broad metal X-axis
plate. Lifting the robot by the thin metal rod will bend the rod.