Suzuki GW250, Руководство по обслуживанию

Страница: 79 / 478

ENGINE 3-31
VALVE STEM END CONDITION
• Inspect the valve stem end face for pitting and wear. If pitting
or wear is present, resurface the valve stem end.
• Make sure that the length
A
is not less than 2.2 mm (0.09 in).
If this length becomes less than 2.2 mm (0.09 in), replace the
valve.

Valve stem end length
A
:
Service Limit (IN. & EX.): 2.2 mm (0.09 in)

09900-20101: Vernier calipers (150 mm)
VALVE SPRING
The force of the coil spring keeps the valve seat tight. Weak-
ened spring result in reduced engine power output, and often
account for the chattering noise coming from the valve mecha-
nism.
• Check the valve spring for proper strength by measuring their
free length and also by the force required to compress them.
• If the spring length is less than the service limit, or if the force
required to compress the spring does not fall within the range
specified, replace the valve spring.

Valve spring free length (IN. & EX.):
Service Limit (INNER): 32.1 mm (1.26 in)
(OUTER): 31.8 mm (1.25 in)

09900-20101: Vernier calipers (150 mm)

Valve spring tension (IN. & EX.):
Standard (INNER): 58.2 – 71.2 N (6.0 – 7.3 kgf,
13.2 – 16.1 lbs)/28.0 mm (1.10 in)
Standard (OUTER): 158.7 – 182.5 N (16.2 – 18.6 kgf,
35.7 – 41.0 lbs)/31.5 mm (1.24in)
REASSEMBLY
Reassemble the cylinder head in the reverse order of diassem-
bly. Pay attention to the following points:
• Install the valve spring seat
1
.
• Apply molybdenum oil solution to the new oil seal
2
, and
press-fit it into position.

MOLYBDENUM OIL SOLUTION