G A L A X Y N A S L X 5 C O N F I G U R A T I O N A N D S Y S T E M I N T E G R A T I O N G U I D E
88
Section 3 Menu Functions
Function: FTP settings fig 3.2.2b
To enable FTP services check use ftp.
FTP port:
Determines the port the FTP service is listening to.
Max clients
: Limits the total number of concurrent FTP connections.
Max clients per host
: Limits the total number of connections originating from a single host.
Min. port:
Minimal port number for the FTP passive mode. Needs to be smaller than the maximum
port
number.
Max. port:
Maximal port number for the FTP passive mode. Needs to be greater then 1024.
Encryption settings:
SSL
: Data transfer will be encrypted with the SSL protocol.
None
: Data will be send without any encryption.
Advanced settings
Idle timeout:
This option allows you to set a timeout (in seconds) for an idle connected client.
An idle client does not receive any data on either the control or the data connection. Inputting 0
equals no timeout.
No transfer:
This option allows you to set a timeout (in seconds) for a connected client whose
data connection is idle (e.g. it is not sending or receiving data). Control connection is not
subject to this timeout. Inputting 0 equals no timeout.
Passive port range:
Range of port addresses when FTP service is connected in passive mode.
FXP support:
Enables support for the File eXchange Protocol.
Delay engine on:
Enables runtime delay. It is recommended to keep this option on for security
purposes.
Figure 3.2.2b
