RITE-HITE FasTrax XL, Инструкция по установке/обслуживанию/эксплуатации

Страница: 61 / 92

Rite‑Hite
®
Installation/Service/Owner's Manual
FasTrax
®
XL
Publication: AMEN00316 2020-07-06 61
OPERATION
Verify Operation
Verify operation after initial installation and according to
"Planned Maintenance" on page 62
The door operations are controlled by a Universal
Controller (i-COMM 3) The controller is set up and
programmed during testing at the factory Only Rite-Hite
authorized service technicians should change the
programming
NOTE: Advise pedestrians to use man doors if present
and not to lean into the door way
1 To quickly determine if the door is ready to operate:
a Open the control box
b Look at the row of (X) green Input LEDs on the
i-COMM 3 and the label to verify proper state
2 Check and remedy:
• Pillow block bearing set screws tightened to 66 to
70in-lb [8Nm]
• Wires are connected for the photoeyes
• All loose wires are secured away from moving parts
3 With the power on, press the “OPEN” button, the door
should open and close automatically after a short
delay To adjust the amount of door open time, the
setting must be changed in the i-COMM 3 controller
4 Operate and observe the door opening to make sure
that it fully opens Observe the closing action to make
sure that the door operates smoothly, and fully closes
without excessive curtain ripple Black edging of
curtain should not impact the floor
If it is necessary to adjust Open or Close positions,
refer to i-COMM 3 manual
5 While the door is closing, block the reversing
photoeyes The door should reverse direction,
move to the open position, and continue to operate
6 Using end user material handling equipment:
• Approach door slowly and verify that all the
activation devices that are being used are operating
properly DO NOT attempt to drive through a door
that is in a fault
• Use caution (honk horn) and look in all directions
when approaching a door that is closing and ensure
that the door will reverse before proceeding
NOTE: A fault will occur if the optional non-powered chain
hoist is operated Press the green “OPEN/RESET” button
to return to normal operation
Photoeye Adjustment
DO NOT change the location of photoeyes (they are
disabled before the curtain passes by) They MUST be at
18in [457mm] and 54in [1372mm]
Locate the receiver photoeye (A) on the drive side lower
track Located on the top of the photoeye are 2 LEDs
A
C
B
• The orange LED (B) will be on when the output is
energized
• If the green LED (C) is blinking, either the photoeye is
out of alignment or the short circuit protection of the
photoeye has been triggered
• The green LED (C) indicates if the photoeye has power
The source photoeye on the non-drive lower track will only
have the green LED for power
Power Outage Procedure
See "Power Outage Procedure" on page 36
Figure 80