RITE-HITE FasTrax XL, Инструкция по установке/обслуживанию/эксплуатации

Страница: 34 / 92

FasTrax
®
XL
Installation/Service/Owner's Manual
Rite‑Hite
®
34 Publication: AMEN00316 2020-07-06
I
H
Q
T
U
8 Attach the smaller of the 2 springs (K) to the brake
release eye bolt (L) ( Figure 55 on page 35 )
Smaller spring should be toward the outside
9 Route the short cable (M) through the pulley, then
through the hole in the bottom of the engagement arm
bracket and clamp it behind the pressure plate The
spring plate (N) should sit level when hanging without
the hand lever engaged ( Figure 55 on page 35 )
10 Place the drive chain (H) around the chain hoist
sprocket and then place the drive chain over the drive
tube driven sprocket
11 Use a straight edge to align chain sprockets Failure
to do so may result in noise and premature wear
12 With the hand chain sprocket in toward the motor and
the sprocket in line with the drive sprocket, plumb,
level, mark and drill hole locations (toward bottom
of the slot, to prevent chain hoist from sliding up) for
fastening chain hoist assembly (I) to the wall Use
fasteners suitable to hold unit to the wall
13 Make sure chain is tight and not causing either shaft
to bend
Figure 53
Figure 54
INSTALLATION
N.P.O.
(OPTIONAL)
Continued