RITE-HITE FasTrax XL, Инструкция по установке/обслуживанию/эксплуатации

Страница: 36 / 92

FasTrax
®
XL
Installation/Service/Owner's Manual
Rite‑Hite
®
36 Publication: AMEN00316 2020-07-06
INSTALLATION
N.P.O.
(OPTIONAL)
Continued
Power Outage Procedure
Follow lockout procedures to prevent the door from
operating should power be restored while working on.
Counterweight or through-wall brake release is not
available.
Use a Non-Powered Manual Open option for opening or
closing the door in the event of a power outage.
WARNING/AVERTISSEMENT
N.P.O. (Non-Powered Opening) is intended to
operate door in the event of a power loss.
Disconnect power during any other operation.
N.P.O. (OHT/L'ouverture non motorisée) est
destinée à actionner la porte en cas de panne de
courant.
Débrancher l'alimentation pendant toute autre
opération.
N.P.O. Equipped:
1. To release brake and engage N.P.O., rotate the hand
lever completely down.
2. To raise the door - pull the front hand chain down.
3. To lower the door - lift the chain blocker and pull the
rear hand chain down.
NOTE: The chain blocker prevents the door from
closing. Once the hand lever is pulled, the door goes
into fault and cannot be automatically operated and
the screen will display "Door Faulted, Emergency
Stop".
To Return Door to Operation:
1. Engage brake and release N.P.O. by rotating the
hand lever up and lock in place.
2. Hand chain should rotate freely, ensuring assembly is
disengaged.
3. Reconnect power. Press green Open/Reset button.
NOTE:
In the event that the curtain is lowered or
raised beyond the drive tube, the encoder positions
will need to be re-setup.
Without N.P.O.
CAUTION/ATTENTION
Use caution with lift configurations. The weight of
the curtain may cause the curtain to close rapidly.
Soyez prudent avec les configurations
d'ouverture. Le poids du rideau peut provoquer
sa fermeture rapide.
NOTE: Procedure should only be performed by trained
technicians.
A
1. On the door mounted side, a ladder or a scissors lift
will be required to release the brake.
2. To hold brake release on, rotate brake release hold
down bracket (A) to vertical position.
3. To engage brake, rotate bracket horizontal.
4. While the brake is released, turn the roller tube to
lower or raise the door. The force required will vary
based on size and lift configuration.
NOTE: The roller tube can be turned by hand or a
wrench placed on the non-drive shaft and turned.
Figure 56