Ricoh AFICIO AP306, Руководство по установке

Страница: 329 / 382

Draft 2000/06/22
NetWare 3.x - Advanced Settings
55
4
Setting Up as a Remote Printer
A
Log on to the file server as a Supervisor or a Supervisor equivalent.
B
Run the NIB Setup Tool.
Reference
⇒
P.48 “Running the NIB Setup Tool”
C
Click [Property Sheet] and click [OK] .
The [Browse] dialog box of the Network Interface Board appears.
D
Click [IPX protocol] .
E
Click the IPX address of the Network Interface Board which is to be config-
ured, and click
[Next >] .
Note
❒
If you do not know which Network Interface Board you are configuring,
see a network configuration page to confirm the MAC address (Network
Address).
F
Confirm that the MAC address and IPX address are correct, and click [Fin-
ish]
.
The
[NIB Setup Tool]
window appears.
G
Click [Configure] .
The property sheet appears.
H
Click the
[General]
tab, and type the name of the print server into the
[Device
Name] box.
I
Click the [NetWare] tab, and make the following settings.
A
In the [Print Server Name] box, type the name of the print server.
B
In the [File Server Name] box, type the name of the file server in which a
print server is to be created.
Clicking
[Browse]
, you can select a file server among those listed in the
[Browse] dialog box.
C
In the [Print Server Operation Mode] group, click [As Remote Printer] .
D
In the [Remote Printer No.] box, type the printer number.
Important
❒
Use the same printer number as that to be created in the printer server.
E
Click [OK] to close the property sheet.
F
After a confirmation dialog box appears, click [OK] .