REXROTH IndraDrive Fc FCS01, Руководство по эксплуатации

Страница: 132 / 238

11-44
Parameterization Rexroth IndraDrive FCS01.1
DOK-INDRV*--FCS01*****-IB01_EN-P
Parameter Setting value / description / note Device Supervisor Parameter record
P557 Power braking resistor
S
0.00 ... 20.00
kW
[
0
.00 ]
Continuous power (nominal power) of the resistor for calculating the maximum braking
power.
0.00 = monitoring deactivated
P558 Magnetization time
S P
0 / 1 / 2 ... 500
ms
[ 1 ]
The ISD control can only work properly if there is a magnetic field in the motor. For this
reason, DC current is applied to the motor before the start. The duration depends upon the
motor dimension and is automatically set in the FC factory setting.
For time-critical applications, magnetization time can be set or deactivated.
0 = switched off
1 = automatic calculation
2 ... 500 = correspondingly set time in [ms]
Note: Excessively small values can reduce dynamics and torque development on
start-up.
P559 DC lag time
S P
0.00 ... 2.50 s
[ 0.50 ]
After a stop signal and expiry of the brake ramp, a DC current is temporarily applied to the
motor in order to completely deactivate the drive. Depending on mass inertia, the time of
current application can be set via this parameter.
The amount of current depends on the previous braking process (current vector control) or
on the static boost (linear characteristic).
P560 Save to EEPROM
S
0 ... 1
[ 0 ]
0 = Changes of the parameter settings are lost when the FC is disconnected from the
mains.
1 = All parameter settings are automatically written into the EEPOM. Thus, they are
retained when the FU is disconnected from the mains.
Note: When the USS protocol is used to modify parameters, please ensure that the
maximum number of write cycles to the EEPROM (100.000 x) is not
exceeded.