Raritan Dominion SX II, Руководство администратора

Страница: 27 / 272

Chapter 3: Access and Use Remote Console Features
20
Use a standard Cat5 cable to connect your target device to an
available port on the back of SX II.
Note: Check the pin definition of the RJ45 port on the target. It
should match the pin definition on SX II.
Or
If needed, connect a Raritan Nulling Serial Adapter to the serial port
on your target, then plug a standard Cat5 cable into the adapter.
Connect the other end of the cable to an available port on the back of
SX II.
5. Flip the power switch(s) to turn SX II on.
Next, connect SX II to your network and configure your network settings
for the first time.
See Initial SX II Configuration Using Command Line Interface
(Optional) (on page 12) or Configure SX II Network Settings from the
Remote Console.
Connect a Laptop to SX II Using a Cross-Over Cable (Optional)
The first time you configure SX II, if you are connecting from the LAN
port on laptop to the LAN1 port on SX II using a crossover cable, do the
following -
1. Use cross-over cable to connect between SX II LAN1 and the laptop
LAN port.
2. Set the Static IP of the LAN port that is connected to SX II to
192.168.0.191
and Network Mask to
255.255.255.0
.
3. Launch your browser and access SX II via
192.168.0.192
.