R&S NRP2, Руководство пользователя

Страница: 300 / 437

Remote Control - Commands
R&S
®
NRP2
282 User Manual 1173.9157.02 ─ 03
Parameters:
<exclude_stop> float_value
Range:
depending on sensor
*RST: depending on sensor
[SENSe<[1]..4>]:TRACe:AVERage[:STATe] <state>
Switches the filter function of a sensor on or off for the Trace mode. When the filter is
switched on, the number of measured values set with
[SENSe<[1]..4>]:AVERage:COUNt
is averaged. This reduces the effect of noise so
that more reliable results are obtained.
Parameters:
<state> ON | OFF
*RST:
depending on sensor
[SENSe<[1]..4>]:TRACe:AVERage:COUNt <filter_length>
Sets the length of the filter for the Trace mode. The wider the filter, the lower the noise
and the longer it takes to obtain a measured value.
Note:
The
SENS:TRAC:AVER:COUN
command switches the automatic filter length switchover
off (
SENS:TRAC:AVER:COUN:AUTO OFF
).
Parameters:
<filter_length>
The filter length can only be 1, 2, 4, 8, 16,..., 2
n
. If the entered filter
length is not a power of two, the value is rounded to the next 2
n
value without an error message.
Range:
depending on sensor
*RST: depending on sensor
[SENSe<[1]..4>]:TRACe:AVERage:COUNt:AUTO <state>
Can be used to automatically determine a value for
[SENSe<[1]..4>]:AVERage:COUNt
for the trace mode.
SENSe (Sensor Commands)