R&S NRP2, Руководство пользователя

Страница: 275 / 437

Remote Control - Commands
R&S
®
NRP2
257 User Manual 1173.9157.02 ─ 03
Parameters:
<NR1>,<NR1> 1st <NR1>
01: Generator on/off (2nd parameter 0: on / 1: off)
02: Power stage (2nd parameter 0: -20 dBm, 1: 0 dBm)
03: LED state (2nd parameter 0: off, 1: on, 0x02: blinking)
04: Start of calibration
05: Setting of potentiometer 1 (2nd parameter –128 to 127)
06: Setting of potentiometer 2 (2nd parameter –128 to 127)
07: Setting of potentiometer 3 (2nd parameter –128 to 127)
08: Setting of potentiometer 4 (2nd parameter –128 to 127)
09: Confirm calibration
10: Abort calibration
2nd <NR1>
Data if 1st parameter 01, 02, 03, 05, 06, 07 or 08.
0 if 1st parameter 04, 09 or 10.
Usage: Event
Options: R&S NRP2-B1
OUTPut:TTL:ACTive <string>
Specifies whether the value set via
OUTP:TTL:LVOL (LOW)
or via
OUTP:TTL:HVOL
(HIGH)
should be applied if the measured value causes a limit violation at the TTL output.
Parameters:
<string> LOW | HIGH
*RST:
LOW
OUTPut:TTL:FAIL <mode>
Specifies the value which should be applied if the measured value causes a limit violation
at the TTL output.
Note: The
OUTP:TTL:ACT
and
OUTP:TTL:FAIL
commands are identical, except for
the opposite meaning of the parameters.
Parameters:
<mode> HIGH
The value set via
OUTP:TTL:LVOL
is applied if the measured
value causes a limit violation at the TTL output.
LOW
The value set via
OUTP:TTL:HVOL
is applied if the measured
value causes a limit violation at the TTL output.
*RST:
HIGH
OUTPut