RADWAG MAS 1. Y, Руководство пользователя

Страница: 18 / 201

- 18 -
Do not use cleansers containing abrasive substances.
Next, using cloth and cleanser-water solution (soap, dishwashing liquid) gently rub the
cleaned surface.
Avoid using cleanser without water since it may result with damage of the cleaned surface,
please mind that large amount of water mixed with cleanser is a must.
Cleaning Aluminium Components
While cleaning aluminium components use products acid by nature, e.g. spirit vinegar,
lemon. Do not use cleansers containing abrasive substances. Avoid using hard brush, this
may cause scratches. It is recommended to use microfibre cloth.
While polishing the surface use circular movements. Use clean, dry cloth to make the
surface shine.
Cleaning stainless steel components:
Avoid using cleansers containing any corrosive chemicals, e.g. bleach (including chlorine).
Do not use cleansers containing abrasive substances. Always remove the dirt using
microfiber cloth to avoid damage of protective coating.
In case of a daily maintenance:
1. Remove the dirt using cloth dipped in warm water.
2. For best results, add a little bit of dishwashing detergent.
Cleaning ABS components:
To clean dry surfaces and avoid smudging, use clean non-colouring cloths made of cellulose
or cotton. You can use a solution of water and detergent (soap, dishwashing detergent, glass
cleaner). Gently rub the cleaned surface and let it dry. Repeat cleaning process if needed.
In the case of hard to remove contamination, e.g. residues of adhesive, rubber, resin,
polyurethane foam etc., you can use a special cleaning agents based on a mixture of
aliphatic hydrocarbons that do not dissolve plastics. Before using the cleanser for all
surfaces we recommend carrying out tests. Do not use cleansers containing abrasive
substances.
3.5. Connecting the Module to the Mains
The module can be connected to the mains only using a power supply that comes
standard with the particular model. Nominal voltage of the power supply (specified on
the power supply data plate) has to be compatible with the power from the mains.
Plug the instrument to the mains – connect the power adapter to the socket, next plug its
connector to interface located at the side of the instrument housing.
Upon plugging the instrument to the mains the software runs. During the module start, the
test of an internal adjustment mechanism takes place (the internal adjustment weight is put
down and lifted up).