Perrot Greenkeeper Feedback, Руководство пользователя

Страница: 68 / 143

User Manual
Bed ‐ GK 1+2e Rev. 03.04.2019 Page 68 / 143
8. Program Configuration
In Greenkeeper Win you create various irrigation program configurations. These are then tested
using an internal program test. During the test the Pump Flow Manager which is integrated in
Greenkeeper uses the master data to calculate an optimum way of how the program will run.
Finally the resulting data is, within a matter of seconds, downloaded to the VCU.
Greenkeeper supports 3 different program types.
Description of program types
1. Single valves
All the valves, for which Precipitation Volume or Duration have been entered in the program,
taking into consideration the pump data and the values for the valves entered, until the
optimum pump capacities are achieved.
The sequence of valve opening is determined by the program. It is, however, possible to
change the sequence.
2. Sectors
In this program all the valves within a pre ‐ defined sector open, taking into consideration the
pump data. Only the optimum flow rate within a sector is calculated. The sequence of the
sectors is determined by the program. However, in the sectors program it is possible to enter
the sequence you require.
3. Manual programs
This program is not supervised by the Flow Manager. You explicitly define which valves are
to open in a particular step. You also determine which pump(s) will start. The program
operates in steps. This means that one step is executed after the other. A maximum of 8
valves can be assigned to each step. All valves in a step open simultaneously. It is, however,
possible to set a delay for the individual valves. See Chapter 7.6 (General)
Please check the pump capacity. Incorrect data may cause pump overloading.