Perrot Greenkeeper Feedback, Руководство пользователя

Страница: 45 / 143

User Manual
Bed ‐ GK 1+2e Rev. 03.04.2019 Page 45 / 143
7.6.3 Minimum pump run time: (SPECIAL FUNCTION)
The minimum pump run time will be entered in this field.
This avoids a permanent start/stop (in short intervals) of the pumps.
This function is just active if irrigation programs (automatic or manual start) are active.
Input range: 15 – 60 sec. (only 3 sec. Steps allowed)
Standard: 15 sec.
7.6.4 Interval time to calculate the flow: (SPECIAL FUNCTION)
During an irrigation program the optimum pump sequence will be determined depending on the
current calculated flow. Through this the influences of a variable flow will be reduced. It creates an
optimal pump sequence, determined by the integrated average flow calculation.
This represents the time how often in the irrigation cycle the average should be calculated,
depending on the current flow of the valve. The 60 sec. flow of the valve is the decisive factor for an
optimal pump sequence, depending of the average value in the last 60 sec.
Standard: 0 sec.
7.6.5 Maximum retention time to open the valves (ONLY FOR BI ‐ DIR ‐ DECODER)
This time represents how many seconds the system accepts the status „ valve closed “ until an error
message will be created, if a decoder will be activated. This function asked for the status of the flow
sensor, if a decoder will be activated.
7.6.6 Maximum retention time to close the valves (ONLY FOR BI ‐ DIR ‐ DECODER)
This time represents how many seconds the system accepts the status „ valve closed “ until an error
message will be created, if a decoder will be activated.
This function asked for the status of the flow sensor, if a decoder will be activated.