Perrot Greenkeeper Feedback, Руководство пользователя

Страница: 128 / 143

User Manual
Bed ‐ GK 1+2e Rev. 03.04.2019 Page 128 / 143
14.4.7 Service Menu 05
Two different service functions are available in this menu.
PERROT REGNERBAU REMOTE TERMINAL ‐ SERVICE 16.01.12 13:02:19
VCU Status :100 ‐ No error
[1] ‐ Reset VCU error
[2] ‐ Close all manual open valves
Last command: [2] ‐ close all manual open valves
The VCU Status field indicates the current status of the decoder line.
The following messages can be displayed:
100 ‐ No Error
No error has been detected.
101 ‐ Line init
If this message shows up the decoder line is being initialised.
Once the initialization is finished a message follows.
100 to 105.
102 ‐ Sync error
The decoder line cannot be synchronised.
Contact a Perrot representative near you.
103 ‐ Ground error
The earth current in the decoder cable is too high.
Check the decoder cable for defects. (Cable connections, etc.)
104 ‐ Load error
The current consumption of the decoder line is too high.
Check the decoder line for short ‐ circuits and check the decoder itself.
105 ‐ Volt error
The output voltage of the decoder line is too low.
Contact a Perrot representative near you.