Paradyne BitStorm 4800 Express, Руководство пользователя

Страница: 97 / 208

A. CLI Command Descriptions
4800-A2-GB20-10 July 2002
A-59
show interface ethernet {
port_id
} configuration
Minimum Access Level: User
The show interface ethernet configuration command displays configuration information
for all Ethernet ports or a specified port.
port_id – Specifies that the display should be limited to this specified port. If all is
specified, information is displayed for all Ethernet ports.
configuration – Specifies that the port’s configuration should be displayed.
Example:
IAC#show interface ethernet 1/mgmt configuration
Display results:
„
current link up time – The number of days, hours, minutes, and seconds the interface
has been active.
The remainder of the display shows configuration parameters for the port. See the
configure interface ethernet commands in
Table A-10, Configure Interface Command ,
for more information about the parameters.
show interface ethernet {
port_id
} statistics
Minimum Access Level: User
The show interface ethernet statistics command displays statistics for all Ethernet ports
or a specified port.
port_id – Specifies that the display should be limited to this specified port. If all is
specified, information is displayed for all Ethernet ports.
statistics – Specifes that the error statistics for the specified port should be displayed.
Example:
IAC#show interface ethernet 1/mgmt statistics
Display results:
„
ethernet link – The status of the link:
– dormant – The link has no device attached.
– down – The link is down.
– unknown – The link’s status cannot be determined.
– up – The link is enabled and ready to send packets.
„
current link up time – The number of days, hours, minutes, and seconds the interface
has been active.
„
rate – The data rate of the port.
„
mode – The duplex mode: full duplex or half duplex.
„
connector type – The connector used for the link: rj45 or fiber.
„
total bytes rx – Number of bytes received on the port.
„
total bytes tx – Number of bytes transmitted by the port.
„
total frames rx – Number of bytes received on the port.
„
total frames tx – Number of bytes transmitted by the port.
„
total frames discarded – Number of frames discarded by the port.
Table A-32. Show Command (8 of 20)