Paradyne BitStorm 4800 Express, Руководство пользователя

Страница: 54 / 208

A. CLI Command Descriptions
A-16
July 2002 4800-A2-GB20-10
configure interface dsl [
port_id
] show
Minimum Access Level: Administrator
The configure interface dsl show command displays parameters for a DSL port without
leaving configuration mode.
port_id – Identifies the port whose configuration is to be displayed. If no port is specified,
the port currently in configuration mode, if any, is displayed.
Examples:
IAC#configure interface dsl 1/7 show
IAC(configure-interface-dsl-1/7)#show
configure interface dsl {
port_id
} state {disabled | enabled}
Minimum Access Level: Administrator
The configure interface dsl state command specifies the availability of a DSL port.
port_id – Identifies the port to be configured. The possible forms of the identifier are
described in
System Terminology in Chapter 2, Terminology and Conventions.
state – Specifies the availability of the port. Valid choices are disabled and enabled. The
default is enabled.
Example:
IAC#configure interface dsl 1/24 state enabled
configure interface dsl {
port_id
}
target-downstream-margin {
margin
}
Minimum Access Level: Administrator
The configure interface dsl target-downstream-margin command specifies the Signal
to Noise Ratio (SNR) margin, in dB, required at startup for traffic from the port toward the
CPE. See
SNR Margin (DSL Interfaces) on page A-22 for more information.
port_id – Identifies the port to be configured. The possible forms of the identifier are
described in
System Terminology in Chapter 2, Terminology and Conventions.
margin – Valid choices are 2–15 dB in 1 dB increments. The default is 6.
Example:
IAC#configure interface dsl 1/1 target-downstream-margin 3
configure interface dsl {
port_id
}
target-upstream-margin {
margin
}
Minimum Access Level: Administrator
The configure interface dsl target-upstream-margin command specifies the SNR
margin, in dB, required at startup for traffic toward the port from the CPE. See
SNR
Margin (DSL Interfaces)
on page A-22 for more information.
port_id – Identifies the port to be configured. The possible forms of the identifier are
described in
System Terminology in Chapter 2, Terminology and Conventions.
margin – Valid choices are 2–15 dB in 1 dB increments. The default is 6.
Example:
IAC#configure interface dsl 1/1 target-upstream-margin 3
Table A-10. Configure Interface Command (6 of 11)