Paradyne BitStorm 4800 Express, Руководство пользователя

Страница: 55 / 208

A. CLI Command Descriptions
4800-A2-GB20-10 July 2002
A-17
configure interface ethernet {
port_id
}
connector {rj45 | fiber}
Minimum Access Level: Administrator
The configure interface ethernet connector command specifies the physical interface
to be used when both interfaces are active at the same time. Ordinarily the BitStorm 4800
uses the fiber optic port if an SFP transceiver is detected, so this command provides a
way to force the use of the 8-position modular jack even if a transceiver is installed.
port_id – Identifies the Ethernet port to be configured. The possible forms of the identifier
are described in
Ethernet Port ID in Chapter 2, Terminology and Conventions.
connector – Valid choices are:
– rj45 – The BitStorm 4800 uses the 8-position modular jack for the port_id interface.
– fiber – The BitStorm 4800 uses the fiber optic port for the port_id interface.
Example:
IAC#configure interface ethernet 1/uplink connector rj45
configure interface ethernet {
port_id
}
flow-control {enabled | disabled}
Minimum Access Level: Administrator
The configure interface ethernet flow-control command specifies whether flow control
should be used on the port.
port_id – Identifies the Ethernet port to be configured. The possible forms of the identifier
are described in
Ethernet Port ID in Chapter 2, Terminology and Conventions.
flow-control – Valid choices are disabled and enabled. The default is enabled.
Example:
IAC#configure interface ethernet 1/mgmt flow-control enabled
configure interface ethernet {
port_id
}
mode {auto | manual}
Minimum Access Level: Administrator
The configure interface ethernet mode command specifies whether the duplex mode
and rate are automatically set, and the crossover type automatically sensed.
port_id – Identifies the Ethernet port to be configured. The possible forms of the identifier
are described in
Ethernet Port ID in Chapter 2, Terminology and Conventions.
mode – Valid choices are:
– auto – The BitStorm 4800 automatically senses the rate and duplex mode. This is
the default.
– manual – The administrator must set the rate and duplex mode.
Example:
IAC#configure interface ethernet 1/mgmt mode manual
Table A-10. Configure Interface Command (7 of 11)