Paradyne BitStorm 4800 Express, Руководство пользователя

Страница: 56 / 208

A. CLI Command Descriptions
A-18
July 2002 4800-A2-GB20-10
configure interface ethernet {
port_id
}
rate {10full | 10half | 100full | 100half | 1000full |
1000half}
Minimum Access Level: Administrator
The configure interface ethernet rate command specifies the duplex mode and rate if
mode is set to manual.
port_id – Identifies the Ethernet port to be configured. The possible forms of the identifier
are described in
Ethernet Port ID in Chapter 2, Terminology and Conventions.
rate – Valid choices are:
– 10full – 10 Mbps and full duplex
– 10half – 10 Mbps and half duplex
– 100full – 100 Mbps and full duplex
– 100half – 100 Mbps and half duplex
– 1000full – 1000 Mbps and full duplex
– 1000half – 1000 Mbps and half duplex
Example:
IAC#configure interface ethernet 1/mgmt rate 100full
configure interface ethernet [
port_id
] show
Minimum Access Level: Administrator
The configure interface ethernet show command displays parameters for an Ethernet
port without leaving configuration mode.
port_id – Identifies the port whose configuration is to be displayed. If no port is specified,
the port currently in configuration mode, if any, is displayed.
Examples:
IAC(configure-interface-ethernet-1/uplink)#show
IAC#configure interface ethernet 1/uplink show
configure interface ethernet {
port_id
} xover {mdi | mdix}
Minimum Access Level: Administrator
The configure interface ethernet xover command specifies the crossover type when
mode is set to manual.
port_id – Identifies the Ethernet port to be configured. The possible forms of the identifier
are described in
Ethernet Port ID in Chapter 2, Terminology and Conventions.
xover – Valid choices are:
– mdi – The port is connected to a Network Interface Card (NIC).
– mdix – The port is connected to a hub.
Example:
IAC#configure interface ethernet 1/mgmt xover mdi
Table A-10. Configure Interface Command (8 of 11)