Paradyne BitStorm 4800 Express, Руководство пользователя

Страница: 52 / 208

A. CLI Command Descriptions
A-14
July 2002 4800-A2-GB20-10
configure interface dsl {
port_id
}
linkupdown-trap {disabled | enabled}
Minimum Access Level: Administrator
The configure interface dsl linkupdown-trap command specifies whether an SNMP
trap should be sent upon link up and link down events.
port_id – Identifies the port to be configured. The possible forms of the identifier are
described in
System Terminology in Chapter 2, Terminology and Conventions.
linkupdown-trap – Valid choices are:
– disabled – No traps are sent upon link up and link down events.
– enabled – A trap is sent upon a link up or link down event. This is the default.
Example:
IAC#configure interface dsl 1/1 linkupdown-trap disabled
configure interface dsl {
port_id
} max-downstream-speed {
rate
}
Minimum Access Level: Administrator
The configure interface dsl max-downstream-speed command specifies the maximum
rate, in Kbps, available for traffic from the port toward the CPE. If behavior is set to fixed,
this is the only downstream rate.
port_id – Identifies the port to be configured. The possible forms of the identifier are
described in
System Terminology in Chapter 2, Terminology and Conventions.
rate – Valid rates are:
– For dmt and ansi: 64 to 8128 Kbps in 32 Kbps increments. The default is 8128.
– For g.lite: 64 to 4000 Kbps in 32 Kbps increments. The default is 4000.
Example:
IAC#configure interface dsl 1/2 max-downstream-speed 512
configure interface dsl {
port_id
} max-upstream-speed {
rate
}
Minimum Access Level: Administrator
The configure interface dsl max-upstream-speed command specifies the maximum
rate, in Kbps, available for traffic toward the port from the CPE. If behavior is set to fixed,
this is the only upstream rate.
port_id – Identifies the port to be configured. The possible forms of the identifier are
described in
System Terminology in Chapter 2, Terminology and Conventions.
rate – Valid rates are 32 to 1024 Kbps in 32 Kbps increments. The default is 1024.
Example:
IAC#configure interface dsl 1/1 max-upstream-speed 128
Table A-10. Configure Interface Command (4 of 11)