Omron NT - SUPPORT TOOL 07-1995, Руководство по эксплуатации

Страница: 56 / 225

37
“Scr list” Screen
Section 3-5
(3) The procedure after this point differs according to the type of data: see the
scheme below. Specify the data to be read, the reading source and reading
destination by following the directions on the screen in order to read the data.
Confirmation of
reading execution
information of
data to be read
Screen data
Reading source
screen information
Reading destination
screen information
Overwrite/insert
information
Read execution
confirmation
Execution of reading
Mark data
All/part?
All
Read execution
confirmation
Execution of reading
Part
Reading source
range information
(start point, end point)
Read position
information
Read execution
confirmation
Execution of reading
Execution of reading
Numeral table
Character-string table
Direct connection information
I/O comment
Bit memory table
Read execution
confirmation
All/part?
All
Read execution
confirmation
Execution of reading
Part
Image data
Library data
Reading source
code information
Reading destination
code information
Execution of reading
*5 *5
*3 *2 *2
*1
*4
(*1) The following restrictions apply to the data that can be read.
Image data: “30”, “30C”, “610G”, and “610C” only.
Library data: “30”, “30C”, “610G”, and “610C”, Ver.3 or later only.
Direct connection information:
When direct connection used only.
I/O comment:
When direct connection used only
Bit memory table:
“30”, “30C”, “610G”, and “610C”, Ver.3 or later only.
(*2) When the [Tab] key is pressed and a screen number input, the bar cursor
shifts to the specified screen.
(*3) Overwrite: If data already exists at the destination it is overwritten (the
original data is cleared).
Insert: If data already exists at the destination the data is read into the
file without clearing the original data.