Omron NT - SUPPORT TOOL 07-1995, Руководство по эксплуатации

Страница: 214 / 225

195
Error Messages
Appendix B
APPENDIX B
Error Messages
The error messages that may be displayed while using the support tool, and the
action to take in response to them, are shown below.
Error Message Corrective Action
3,000 I/O comments registered. (Confirm)
No more can be registered.
If there unnecessary comments, delete them.
One screen exceeds 16 Kbytes. (Confirm) The maximum data size for one screen is 16 Kbytes. If there is
unnecessary data, delete it (see 3-5 “Screen Selection Screen”
on p.31).
Image/Library area exceeds 64 KBytes. (Confirm) Delete unnecessary data.
The number of bits for cross-referencing
has exceeded 3000. (Confirm)
If there is unnecessary screen data, delete it.
Not usable with this version. (Confirm)
Check usable functions and adjust the tool settings.
The current tool settings (“PT Model”, “Direct Access”) do not
correspond with the specified function.
This file can’t be sent. (Confirm)
Check the tool settings and file (detailed info).
Files displayed in red cannot be transmitted. Match the tool
settings with the file to be transmitted.
Work directory disk capacity insufficient. (Confirm) Set the data in a directory with sufficient free area (1 MB or
greater)
Data directory disk capacity insufficient. (Confirm)
greater).
Seek error detected. (Confirm)
The disk is damaged, or the drive may be faulty. Either replace
the disk or inspect the disk drive
Disk is faulty. (Confirm)
the disk or inspect the disk drive.
Sector not found. (Confirm) Initialize (format) the disk in DOS format before using it.
Check the direct access version. (Confirm) Adjust the tool settings to match the direct connection version of
the selected file.
Error detected in the data (Confirm) Part of the data has been destroyed and it cannot be used as it
is. Delete the data and create it again. Or, if there is backup
data, use that.
Disk may be broken. (Confirm) Replace the disk. If there is a backup disk, use that.
Disk is protected. (Confirm)
[
G G
: Retry
G G
: Abort ]
Try again after releasing the disk’s write protection.
Disk not ready. (Confirm)
[
G G
: Retry
G G
: Abort ]
Set the floppy disk correctly in the designated drive and try
again.
Too many registered channels: correct to MAX value?
(
G G
Yes/
G G
Abort)
The number of registered counter words has been set to two or
more by a batch change operation: this is automatically cor-
rected to one word (see “Batch Changing Bits and Words”,
p.79).