Omron NT - SUPPORT TOOL 07-1995, Руководство по эксплуатации

Страница: 209 / 225

190
Receiving Data
Section 7-3
7-3 Receiving Data
This is the procedure for receiving screen data, memory table data, display histo-
ries, etc., from the PT and storing this data as support tool files, and for receiving
data in screen units, and writing it to the screen data of the support tool.
7-3-1 Data Reception
Use the following procedure to receive all the data in the data memory and write it
to a file.
There are two methods for receiving data, as follows:
S
Receiving all the data in the PT’s data memory and writing it to a file.
S
Receiving data in screen units and writing it to the support tool.
Receiving Data in File Units
Procedure 1. Set the PT to the “Transmit Mode”.
2. Display the “File Selection” screen.
It does not matter where the bar cursor is.
3. Press the [F7] (Rcv.) key.
4. Input the file name of the file to which the received data is to be written.
5. Press the key.
File reception will start.
"
If a file that already exists is specified, a message asking whether or not the file
is to be overwritten will be displayed. If you do not want to overwrite it, press the
[Esc] key.
"
Press the [Esc] key to stop reception part way through.
On completion of reception, the message “Data successfully transmitted” will
be displayed.