113
Setting Touch Switches
Section 4-7
By using the “Lamp/TSW Disp Mode” function in the environmental settings (tool
settings for the “Edit” screen), it is possible to check how touch switches appear on
the PT during operation by viewing the support tool screen.
Procedure 1.
Select “TOUCH SW” on the initial editing screen.
2.
Select the field in which the touch switch is to be registered in the window and
press the
key.
"
To delete an existing touch switch from the field in which it is registered, locate
the cursor at that field and press the [F1] (Delete) key.
Reference:
S
To “increment copy” an existing touch switch into the next input field (increment-
ing the bit number), press the [F2] (iCopy) key with the cursor located in the “Bit”
column at that entry. Note that the next input field must also have an entry in it.
(See p.77).
S
Pressing the [Space] (open) key with the cursor located on the field of a created
window key will open the window that the key specifies. A window opened in this
way can be closed by returning to the initial editing menu and pressing the [Tab]
(redisplay) key.
S
The notify bit display can be changed to a lamp bit display either by pressing the
[Insert] key or by clicking on the word “Bit” with the mouse. While the lamp bit
display is used, “Bit” is displayed.
3.
Make the necessary settings.
S
Function:
On selecting the touch switch function and pressing
, the
window for that touch switch function will be displayed, allow-
ing the appropriate settings to be made. However, specific
windows will not be displayed for the following:
S
Input notification when not using direct connection
S
Character keys (NT30, NT30C, NT612G, NT610C used
with Ver.3 or later version only)
S
Control keys when using an NT20S, NT20M, NT600S, or
NT600M and not using direct connection
S
Noti/Scrn No.:
If not using direct connection, set the screen number of the
screen displayed when the touch switch is pressed. If using
direct connection, set the PC bit used to notify the fact that the
switch has been pressed.
Содержание NT - SUPPORT TOOL 07-1995
