Omron NT - SUPPORT TOOL 07-1995, Руководство по эксплуатации

Страница: 179 / 225

160
Marks
Section 5-1
5-1 Marks
This section describes how to create customized characters and symbols and dis-
play them on the screen.
Marks can be created in three sizes: 16x16, 32x32, or 64x64 dots.
When using an NT20S, NT20M, NT600S, or NT600M, only 16x16 dot marks can
be created.
5-1-1 Mark Creation Procedure
The procedure for creating marks is as follows.
Procedure 1.
Press the [F9] (Mark) key on the “Screen Selection” screen.
2. Specify the size of the mark to be created.
Three sizes are available: 16x16, 32x32, and 64x64 dots.
"
An existing mark can be copied by pressing the [F1] (Copy) key, specifying the
range for the copy source by inputting a start point and end point, and then
specifying the position of the copy destination.
An existing mark can be moved by pressing the [F2] (Move) key, specifying the
range for the move source by inputting a start point and end point, and then
specifying the position of the move destination.
An existing mark can be deleted by pressing the [F3] (Delete) key and specify-
ing the range by inputting a start point and end point.
3. Move the cursor to specify the position at which the mark is to be registered
once it has been created.
4. Create the mark graphic in the creation area.
5. Press the [F8] key to register the created mark.
6. Press the [Esc] key to quit mark creation.
5-1-2 Mark Creation Screen
Marks are created on the mark creation screen.
Up to 224 marks of the 16x16 dot size can be registered.
Since the same registration area is used for each mark size, 32x32 dot marks
occupy four times the area that 16x16 dot marks do, and 64x64 dot marks occupy
sixteen times the area that 16x16 dot marks do.