3
Preparing Equipment
Section 1-1
S
Using the EMS (expansion memory)
The EMS must be loaded to the support tool before using it.
DEVICE=EMM386.SYS /F=C000
Equipment Relating to Transfer of Screen Data
S
RS-232C connecting cable
For the cable specifications, see Section 7 Data Communication, and the Appen-
dix.
Recommended environment
For convenience, you are recommended to use the NT series support tool in the
following environment.
Support tool installation site
: Hard disk
Work directory (tool settings)
: RAM disk
Data directory (tool settings)
: Hard disk
For details on “tool settings”, see 3-3 “Tool Settings” Screen (p.22).
Note
Back up the data stored in the hard disk in a floppy disk.
1-1-2
Before Starting Preparations
Be sure to make a back-up disk for the support tool system disk and keep the origi-
nal somewhere safe.
When making the back-up, ensure that the original disk is write-protected, as
shown below:
Write-protection tag
Содержание NT - SUPPORT TOOL 07-1995
