Omron NT - SUPPORT TOOL 07-1995, Руководство по эксплуатации

Страница: 81 / 225

62
Common Setting Operations
Section 4-2
S
Ref Table
In the case of a character-string display, specify the number of the memory table
to be referenced here. In direct specification, specify the character-string
memory table number, and in indirect specification, specify a memory table
number.
Pressing the [F1] key enables selection from a memory table list.
S
Length
In the case of character-string display, a display area equivalent to the specified
number of characters is created. The character string is displayed displaced as
far to the left as possible in the display area.
S
Size
Specify whether the half-size font or normal font is to be used for one-byte char-
acters here.
However, note that 64x cannot be specified with an NT20S or NT20M.
Note This font specification is not valid in the case of mark data and image data.
Half-size Normal
S
Scale
Characters can be displayed at magnifications from 1x (Equ) to 64x.
Equ Wide High 4x 9x 16x 64x
S
Attribute
Characters can be displayed with any of the following attributes: “Norm” (nor-
mal), “Inv.” (inverted), “Flsh” (flashing), or “Spot”. For screen data of models oth-
er than the NT30C and NT610C, “Flsh” and “Spot” are displayed in yellow on the
support tool screen.
S
Smoothing
This function smooths out the jaggedness that appears in magnified characters.
It can be specified for characters whose magnification is 4x or greater and marks
whose size is 16 x 16 dots or greater.
When using an NT20S, NT20M, NT600S, or NT600M without direct connection,
only decimal display is possible and this setting is therefore ineffective.
With smoothing Without smoothing