Nortel BSG12aw 1.0, Руководство по настройке

Страница: 161 / 200

QoS advanced configuration 161
Configuration Guide
Marking configuration parameters
The following section describes the parameters for configuration of QoS marking located at
Configuration, QoS, Marking tab .
Variable definitions
The following table describes the variables and values to configure markings.
Port based QoS configuration parameters
You can configure the mapping between 802.1p priority and queue on a per port basis.
The following section describes the parameters for configuration of port based QoS located at
Configuration,
QoS, Port-based QoS tab
.
Destination Subnet Mask
Type
the destination subnet mask address for the destination IP address.
Protocol Select the protocol ID to identify the packet flow. Select one of the
following options:
• Any – both TCP or UDP packets are classified using the class map.
• TCP – only TCP packets are classified using the class map.
• UDP – only UDP packets are classified using the class map.
Source Port Type the source port.
The value ranges from 1 to 65535.
Destination Port Type the destination port.
The value ranges from 1 to 65535.
Incoming DSCP Type the incoming Differentiated Services Code Point (DSCP).
The value ranges from 0 to 63.
IP Interface Select the interface from the list or select Any for any interface to be used
for the class map.
The default value is Any.
Variable Value
Select Select a class map.
Class Map Displays a configured class map identifier.
Outgoing Priority Select the 802.1p priority.
The value ranges from 1 to 7.
The default value is 7–802.1p.
Outgoing DSCP Select the outgoing DSCP from the given list.
Value Type the marking value.
Marking Select this check box to enable marking.
Variable Value