Nortel BSG12aw 1.0, Руководство по настройке

Страница: 195 / 200

SIP advanced configuration 195
Configuration Guide
FXO information configuration parameters
The following section describes the parameters for the configuration of the FXO information
located at
Configuration
,
SIP, FXO/FXS, FXO tab
.
Variable definitions
The following table describes the variables and values for configuring FXO information.
Rebooting VoIP
Complete this procedure to reboot VoIP.
G.723 Preference Select the G.723 Preference.
G.726 Frame Size Select the G.726 Frame Size.
G.726 Preference Select the G.726 Preference.
G.729 Frame Size Select the G.729 Frame Size.
G.729 Preference Select the G.729 Preference.
Note: This table contains an entry for the emergency number. You should
configure the emergency number before you enable the SIP server. This ensures
that an emergency call originating on your system reaches its destination if the
SIP server becomes unavailable.
Variable Value
FXO Channel Select the required FXO channel.
Channel Enable Select this check box to enable the administrative status of the FXO
channel.
The channel is available for use only when it is enabled.
Channel Number Type the FXO channel number. This is the FXO number which identifies
the FXO line for an incoming call.
Password Type the password for accessing the FXO channel.
Forward Number Type the forward number. This number is used when an incoming call on
the FXO channel requires forwarding.
Ring Count Type the ring count. This is the maximum number of rings within which
FXO must get an answer from the remote number.
The minimum value is 1 and maximum value is 6.
The default value is 2. This default appears after you configure the
channel number.
Emergency Number Type the emergency number.
On Hook Detection Time Type the on-hook detection time.
The value ranges from 100 to10000 milliseconds.
The default value is 2000 milliseconds. This default appears after you
configure the channel number.