Nortel BSG12aw 1.0, Руководство по настройке

Страница: 40 / 200

40 VLAN configuration
NN47928-500 NN47928-500
2 In the VLAN ID field, type the VLAN ID.
3 In the IP Address field, type the IP address.
4 In the Subnet Mask field, type the subnet mask address.
5 In the MTU field, type the MTU value.
6 Click Add .
End
Variable definitions
The following table describes the variables and values for configuring the virtual interface.
Configuring DHCP pool settings
Complete this procedure to configure DHCP pool settings. You must configure DHCP pool
settings if hosts on the new VLAN need to communicate with other hosts on other VLANs or on
the WAN.
Procedure steps
Step Action
1 From the BSG navigation pane, select Configuration, DHCP, DHCP Server,
Pool Settings tab.
The DHCP Pool Settings pane appears.
2 In the DHCP Pool Id field, type the pool ID.
3 In the DHCP Pool Name field, type the name of the pool.
4 In the Subnet Pool field, type the subnet pool IP address.
Use the same value you entered for Subnet Mask when you configured the
virtual interface.
5 In the Network Mask field, type the network mask IP address.
Variable Value
VLAN ID Type the VLAN identifier.
IP Address Assignment Select the IP address assignment mode.
Select Manual to manually assign the IP address.
Select Dynamic for the System to assign the IP address for the specified
VLAN from Dynamic Host Configuration Protocol (DHCP) server
configured in BSG.
IP Address Type the IP address, if the IP address assignment is Manual.
Subnet Mask Type the subnet mask for the LAN, if the IP address assignment is
Manual.
MTU Type the Maximum Transmission Unit value.
The range is 90 to 9902. The default value is 1500.
If using Fast Ethernet, the MTU frame size must not be larger than 1522.