Nortel BSG12aw 1.0, Руководство по настройке

Страница: 131 / 200

IP routing advanced configuration 131
Configuration Guide
Adding a RIP interface
Complete this procedure to add a RIP interface.
Procedure steps
Step Action
1 From the BSG navigation pane, select Configuration, IP Routing, RIP,
Interfaces tab.
The RIP Interfaces panel appears.
2 From the Interface list, select the interface you want to configure.
3 Click ADD .
End
Variable definitions
The following table describes the variable value for adding a RIP interface.
RIP interface configuration parameters
The following section describes the parameters for configuring RIP on an interface located at
Configuration,
IP Routing, RIP, Interfaces tab
.
Variable definitions
The following table describes the variables and values for modifying a RIP interface.
Retry Count Type the retry count value to update request and update response packet.
The value ranges between 10 and 40.
The default value is 36.
Default Metric Type the default metric value to set the metric for redistributing routes.
The value ranges between 1 and 16.
The default value is 1.
Variable Value
Interface Specifies the interface ID for the RIP that you want to configure.
Variable Value
Select Select an interface on which you want to enable RIP.
Interface Displays the IP address of the interface ID to modify.
Variable Value