Nortel BSG12aw 1.0, Руководство по настройке

Страница: 133 / 200

IP routing advanced configuration 133
Configuration Guide
Prerequisites to adding a RIP neighbor setting
• To configure Neighbor IP address, you must enable Neighbor Filter (see RIP basic settings
configuration parameters (page 130) ).
Variable definitions
The following table describes the variable and value for adding a RIP neighbor setting.
RIP security settings configuration parameters
The following section describes the parameters for configuration of RIP interfaces located at
Configuration,
IP Routing, RIP, Security Settings tab
.
Variable definitions
The following table describes the variables and values for configuring the type of authentication to
use on a specific interface.
Variable Value
IP Address Type the IP address of the neighbor router to which the unicast update is
sent.
Variable Value
Select Select the RIP interface you want to configure.
IP Address Displays the IP address of the RIP interface.
Authentication Type The authentication type. Select one of the following options:
• No Authentication - disables authentication.
• Simple Password - simple password based authentication.
• MD5 - message digest 5 based authentication
The default value is No Authentication.
Authentication Key Type the key used for authentication, if the authentication type is not No
Authentication.
When you modify the Authentication Type (to a type that requires a key),
make sure you also modify the Authentication Key.
The authentication key is an octet string with the string length ranging
between 0 and 16 alphanumeric characters.
The Authentication Key (password) does not appear in the UI after you
configure a RIP security setting.