Nortel BSG12aw 1.0, Руководство по настройке

Страница: 139 / 200

IP routing advanced configuration 139
Configuration Guide
OSPF link state database display parameters
The following section describes the display parameters for the OSPF link state database located
at
Configuration, IP Routing, OSPF, Link State Database tab
.
Variable definitions
The following table describes the variables and values displayed on the OSPF Link State Database
panel.
Gateway Displays the gateway of the OSPF router.
Type Displays the OSPF router type.
Area ID Displays the area ID of the OSPF router
Cost Displays the cost of the OSPF router.
Type 2 Cost Displays the type 2 cost of the OSPF router.
Interface Displays the interface ID of the OSPF interface.
Variable Value
Area ID Displays the Area ID associated with the OSPF address range.
Type Displays the area type.
Link ID Displays the Link Identifier. The value is in the form of an IP address.
ADV Router Displays all of the router Link State Advertisements (LSAs). If IP address
is not included, then the information displayed describes the local router.
Age(seconds) Displays the route age value.
Sequence Number Displays the OSPF sequence number. The OSPF sequence number is a
32 bit signed integer.
The sequence number starts with the value ‘80000001’h or ‘-7FFFFFFF’h.
Checksum Displays the checksum value.
Link Count Displays the link count value.