Nortel BSG12aw 1.0, Руководство по настройке

Страница: 138 / 200

138 IP routing advanced configuration
NN47928-500 NN47928-500
Variable definitions
The following table describes the variables and values for adding an OSPF virtual interface.
OSPF route information display parameters
The following section describes the display parameters for the OSPF route information located
at
Configuration, IP Routing, OSPF, Route Information tab
.
Variable definitions
The following table describes the variables and values displayed on the OSPF Route Information
panel.
Variable Value
Transit Area ID Select the transit area ID.
This is a list of previously configured OSPF interfaces (see OSPF area
configuration parameters (page 135) ).
Neighbor Router ID Type the router ID of the virtual neighbor.
Authentication Type Specifies the authentication type for an interface. Select one of the
following options:
• None - indicates authentication is not required.
• Simple Password - indicates a simple password is required for
authentication.
• MD5 - indicates message digest 5 based authentication.
The default value is None.
MD5 Key ID Type the secret key used to create the message digest appended to the
OSPF packet if the authentication type is MD5.
Authentication Key Type the key required for authentication, if authentication is enabled on
this interface.
Hello Interval Type the Hello Interval.
The range is 1to 65535.
Retransmit Interval Type the Retransmit Interval.
The range is 0 to 3600.
Transmit Delay
Type the Transmit Delay.
The range is 0 to 3600
Dead Interval Type the Dead Interval.
The range is 0 to 2147483647.
Neighbour State Displays the state of the neighbor router, either Up or Down.
This field is displayed after you add an OSPF configuration.
Variable Value
IP Address Displays the IP address of the OSPF router.
Subnet Mask Displays the subnet mask of the router.
TOS Displays the Type of Service (TOS) of the OSPF router