CHAPTER 3 TERMINALS
Issue 5
UNIVERGE NEAX 2000 IPS General Description
Page 104
12NC
Description
R
e
le
a
s
e
2
0
0
0
IP
S
IP
S
D
M
IP
S
D
M
R
Function
960051151233
SPN-SC03B 8ICH(AP)
X
X
-
ISDN station -channel Handler Card:
• Provides the D-Channel signaling interface and
controls a maximum of four ILC cards (Layer 2 and
3).
4.9.3 CCIS
The following cards provide the CCIS interface via point-to-point 2Mbit interface or
Common channel protocol handler. A CCIS interface requires a CCIS card software key
(license).
Use of CCIS over IP does not require additional hardware, in this case only the CCIS
Card and IPT Card software key (license) are required.
12NC
Description
R
e
le
a
s
e
2
0
0
0
IP
S
IP
S
D
M
IP
S
D
M
R
Function
960051151286
SPN-30CCTA-A(AP)
upto
11
X
X
-
CCIS (2 Mbps) Trunk Card:
• Provides a built-in Common Channel Handler (CCH)
for digital 2M Point-to-Point CCIS.
960051151282
SPN-SC00 CCH-D(AP)
X
X
-
Common Channel Handler Card:
• Transmits/receives signals on the common signaling
channel of CCIS.
• Used with SPN-30PRTA-A(AP) to provide Event –
Based CCIS via ISDN PRI.
• Used with SPN-4BRTA-C(AP) to provide Event –
Based CCIS via ISDN BRI.
Note: the SPN-30CCTA-A(AP) card will be replaced by the SPN-DTA with special
firmware.
4.9.4 Q-SIG
QSIG is supported by the 2000 IPS on a Primary rate card (30B+D): SPN-30PRTA
The following features & supplementary services are supported in SW R6.2:
Basic call (BC)
Generic Functional Procedures (GF)
Number identification
Calling Line Identification Presentation (CLIP)
Calling Line Identification Restriction (CLIR)
Connected Line Identification Presentation (COLP)
Connected Line Identification Restriction (COLR)
Name identification
Calling / Connected Name Identification Presentation (CNIP)
Calling / Connected Name Identification Restriction (CNIR)
