9
47. Connect the power outlet electrical connector, if equipped.
48. Position the trim panel onto the quarter panel and seat the
retaining clips fully.
49. Install the three forward screws (4).
50. Install the rear screw (1).
51. Install the tie down (3) and tie down anchor bolt (2).
52. Tighten the bolt to 12 N m (9 ft. lbs.)
53. Position the upper trim panel tab (1) into the C-pillar and seat
the lower side of the trim fully.
54. Install the screw (3).
55. Position the seat belt turning loop (4) to the height ad uster (1).
56. Install the screw (3) and tighten the to 39 N m (29 ft. lbs.).
57. Engage the tab (2) on the lower edge of the trim cover (3) in
the slot below the screw in the turning loop (1). Then press the
upper edge of the trim cover over the top of the turning loop
until it snaps into place.
4/1/2008
K6860274 Rev. 1
