6
29. Fold the seating cushion (7) up.
30. Remove the jack assembly.
31. Remove the fastener (4) securing the center seat belt (3)(for
left seat removal).
32. Remove the fasteners retaining the seat to the cab
fl
oor.
33. Unsnap the trim cover (4) from the rear seat belt turning loop
(3).
34. Remove the screw (5) that secures the seat belt turning loop
to the upper C-pillar (1).
35. Remove the seat belt turning loop from the C-pillar.
36. Using a trim stick C-4755 or equivalent, disengage the
retaining tabs that secure the upper C-pillar trim panel (2) to
the C-pillar and then pull the trim panel away from the C-pillar
and remove the trim panel.
37. Using a trim stick C-4755 or equivalent, disengage the
retaining tabs that secure the lower C-pillar trim panel (7) to
the C-pillar (1).
38. Remove the screw (6) that secures the lower anchor to the
fl
oor panel near the base of the C-pillar.
39. Remove the seat belt (3) from the lower C-pillar trim panel
through the slots provided and remove the trim panel.
All Cabs
NOTE: There are two types of dome lamps available in this vehicle: one with a switch that is activated by
depressing the lamp lens, and one without a switch. The bulb types and service procedures are identical for
both of these lamps.
40. Insert the tip of a small
fl
at bladed screwdriver into the notch
(5) between the lens (2) and the housing (1) on one side of the
dome lamp.
41. Gently pry the end of the lens outward until it unsnaps from
the housing.
42. Swing the lens outward until it is perpendicular to the housing.
43. Pull the lens hinge/retainer end (3) of the housing outward
slightly from the headliner, then slide the exposed end of
the housing away from the mounting hole far enough to
disengage the
fi
xed retainer (4) on the notched end from the
headliner.
44. Pull the lamp away from the headliner mounting hole far
enough to access and disconnect the wire harness connector
from the back of the lamp.
45. Remove the lamp from the vehicle.
4/1/2008
K6860274 Rev. 1
