3
14. Remove the screw (3).
15. Using a trim stick C-4755 or equivalent, separate the bottom
edge of the trim (2) from the pillar and remove off of the upper
locating tab (1).
16. Remove the quarter trim panel
17. Remove the rear screw (1).
18. Remove the tie down anchor bolt (2) and tie down (3).
19. Remove the three front screws (4) and separate the trim panel.
20. Disconnect the power outlet electrical connector, if equipped.
21. Using a trim stick C-4755 or equivalent, remove the driver side
front (1) and rear (2) door sill scuff plates.
22. Remove the cowl trim panel screw (2) and remove the cowl
trim panel.
WARNING: To avoid serious or fatal injury on vehicles equipped with the Supplemental Restraint System
(SRS), never attempt to repair the electrically conductive circuits or wiring components related to the SRS.
Such repairs can compromise the conductivity and current carrying capacity of those critical electrical circuits,
which may cause SRS components not to deploy when required, or to deploy when not required. Any wire
harness containing broken, cut, burned or otherwise damaged electrically conductive SRS wiring, terminals
or connector components must be removed and replaced with an entire new wire harness. Only minor cuts or
abrasions of wire and terminal insulation where the conductive material has not been damaged, or connector
insulators where the integrity of the latching and locking mechanisms have not been compromised may be
repaired using appropriate methods.
4/1/2008
K6860274 Rev. 1
