9
63. Route and secure antenna harness (1) along the HVAC
harness (2).
64. Route and secure antenna up to the back of the radio.
65. Position the coat hook (1) through the headliner (3) and fully
seat the base of the support to the roof panel.
66. Engage the release clip (2).
NOTE: There are two types of dome lamps available in this
vehicle: one with a switch that is activated by depressing
the lamp lens, and one without a switch. The bulb types and
service procedures are identical for both of these lamps.
67. Position the dome lamp (1) to the mounting hole in the
headliner.
68. Reconnect the wire harness connector to the connector on the
back of the lamp.
69. Insert the
fi
xed retainer on the notched end (4) of the lamp
housing up into one side of the mounting hole in the headliner.
70. Slide the notched end of the housing into the mounting hole far
enough to engage the lens hinge/retainer (3) into the opposite
side of the hole in the headliner.
71. Gently and evenly press the lens hinge/retainer end of the
lamp into the mounting hole until the bezel of the lamp
housing is
fl
ush with the headliner.
72. Swing the notched end of the lamp lens (2) into position against the lamp housing, then press on the lens
fi
rmly and
evenly until it snaps into the housing.
Club Cab, Without Rear Jumper Seats
CAUTION: Keep the inner bottom end of the upper C-pillar trim panel away from the cab back trim panel when
removing the upper C-pillar trim panel to prevent scratching the back trim panel.
4/1/2008
K6860274 Rev. 1
