3
9. Remove the two plastic push-pin retainers (2) that secure the
outer front seat belt retractor cover (1) to the outer front seat
belt retractor (3).
10. Raise the retractor cover upward to disengage the two locator
pins on the inside top of the inboard retractor cover from the
locator holes in the top of the retractor.
11. Spread the bottom of the inboard (1) and outboard (3) retractor
cover halves apart and disengage the snaps located at the top
of the cover halves and remove the cover halves.
12. To access the rear door sill scuff plate for removal, use a
trim stick C-4755 or equivalent to disengage enough of the
retaining tabs (2) that secure the door sill scuff plate end of
the cowl trim panel to the retaining clips in the front door sill.
4/1/2008
K6860274 Rev. 1
