6
34. Gently pry the end (5) of the lens (2) outward until it unsnaps
from the housing (1).
35. Swing the lens outward until it is perpendicular to the housing.
36. Pull the lens hinge/retainer end (3) of the housing outward
slightly from the headliner, then slide the exposed end of
the housing away from the mounting hole far enough to
disengage the
fi
xed retainer (4) on the notched end from the
headliner.
37. Pull the lamp away from the headliner mounting hole far
enough to access and disconnect the wire harness connector
from the back of the lamp.
38. Remove the lamp from the vehicle and position the rear
passenger side headliner down to access the antenna area.
39. Cut out the template as marked.
40. Lay out the template on the rear of the roof as indicated and
tape in place.
41. Center punch the two marks ad directed, remove and discard
the template.
CAUTION: Do not drill more than a 6 mm (1/4 in.), failure to do so will result in damage to the vehicles headliner.
42. Drill a 3 mm (1/8 in.) pilot hole at each of the center punched locations.
43. Drill the rear hole to 5 mm (13/64 in.).
44. Drill the front hole to 19 mm (3/4 in.).
45. Debur both of the holes.
46. Apply Mopar® Corrosion Inhibitor, p/n 82300508, to the bare metal surface of the drilled holes.
4/1/2008
K6860274 Rev. 1
