8
35. Center the template on the rear of the roof, aligning the
template with the roof edge.
36. Center punch the two holes marked on the template.
37. Remove the template.
CAUTION: Do not drill more than a 6 mm (1/4 in.), failure to do
so will result in damage to the vehicles headliner.
38. Drill a 3 mm (1/8 in.) pilot hole at each of the center punched
locations.
39. Drill the rear hole to 5 mm (13/64 in.).
40. Drill the front hole to 19 mm (3/4 in.).
41. Debur both of the holes.
42. Apply Mopar® Corrosion Inhibitor, p/n 82300508, to the bare
metal surface of the drilled holes.
43. Clean and prep the area for the antenna.
44. Install the satellite antenna. Tighten to 9 N m (80 in. lbs.).
45. Route the harness along the passenger quarter panel and tape
in place.
4/1/2008
K6860274 Rev. 1
