Mitsubishi MELSEC-Q QD77MS, Руководство пользователя

Страница: 665 / 976

13 - 6
Chapter 13 Control Sub Functions
(3) Setting the dwell time during an OPR retry
The OPR retry function can perform such function as the dwell time using
"
Pr.57 Dwell time during OPR retry" when the reverse run operation is
carried out due to detection by the limit signal for upper and lower limits and
when the machine OPR is executed after the near point dog is turned OFF
to stop the operation.
" Pr.57 Dwell time during OPR retry" is validated when the operation stops
at the "A" and "B" positions in the following drawing. (The dwell time is the
same value at both positions "A" and "B".)
Hardware limit switch
Limit signal OFF
Stop by limit
signal detection
A
OP
Machine OPR start
Reverse run operation
after limit signal detection
Stop by near-point
dog OFF
Near-point dog
Zero signal
Machine OPR
executed again
Pr. 44
B
OPR direction
Fig. 13.3 Setting the dwell time during an OPR retry
[2] Precaution during control
(1) The following table shows whether the OPR retry function may be executed
by the " Pr.43 OPR method".
Pr.43 OPR method
Execution status of OPR retry function
Near-point dog method
: Execution possible
Count method 1) : Execution possible
Count method 2) : Execution possible
Data set method :
Scale origin signal detection method : Execution not possible
(2) Always establish upper/lower limit switches at the upper/lower limit positions
of the machine, and connect a QD77MS module. If the OPR retry function is
used without hardware stroke limit switches, the motor will continue rotation
until a hardware stroke limit signal is detected.
(3) Do not configure a system so that the servo amplifier power turns OFF by
the upper/lower limit switches connected to the QD77MS. If the servo
amplifier power is turned OFF, the OPR retry cannot be carried out.
(4) The operation decelerates upon detection of the hardware limit signal, and
the movement starts in the opposite direction. In this case, however, an
error (104, 105) is not produced.