Mitsubishi A1SD75P1-S3, Руководство пользователя

Страница: 527 / 622

14 - 16
MELSEC-A
14 TROUBLESHOOTING
Division of
error
Error
code
Error name Description Action at occurrence of error
518
Outside
operation pattern
range
The operation pattern setting is “2.”
519
Interpolation
while target axis
is BUSY
Interpolation is started during operation in the
target axis.
520
Unit group
disagreement The unit group of the target axis of interpolation
is different.
521
Illegal
interpolation
description
command
•
Interpolation data is specified with 1-axis
module.
•
Interpolation data is specified for axis 2 with
2-axis module.
522
Command speed
setting error
The command speed is set at “0.”
524
Control method
setting error
The control method setting is out of the range.
At start: Operation does not start.
During operation:
Stopping according to sudden stop
(stopping group 3) setting
(deceleration and stop/sudden
stop) selected in detail parameter 2
(However, deceleration and stop only during
manual pulse generator operation)
525
Auxiliary point
setting error
One of the following cases is applicable with
auxiliary point-designated arc interpolation.
•
Start point = Auxiliary point
•
End point = Auxiliary point
•
The start point, end point and auxiliary point
are in a line.
•
The auxiliary point address or center point
address is out of the range
between -2147483648 and 2147483647.
Positioning
operation
526
End point setting
error
•
The start point is the end point with the
auxiliary point-designated arc interpolation.
•
The end point address is outside the scope of
-2147483648 to 2147483647 in the circular
interpolation with auxiliary point designation
and center point designation.
At start: Operation does not start.
During operation: Immediate stop
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com