Mitsubishi A1SD75P1-S3, Руководство пользователя

Страница: 544 / 622

14 - 33
MELSEC-A
14 TROUBLESHOOTING
Relevant buffer memory address
Axis 1 Axis 2 Axis 3
Setting range
(Setting given in sequence program)
Remedy
1159 1209 1259
<Positioning operation speed override>
1 to 300
1176 1226 1276
<New torque value>
1 to [torque limit setting value]
24 174 324
<Torque limit setting>
1 to 500
Set a value within the setting range.
Refer to section “5.3 List of positioning
data” for the command speed.
Bias speed at start
12, 13 162, 163 312, 313
<Command speed, bias speed at start>
<In standard mode>
0 to 1000000 [pulse/s]
0 to 600000000 [mm/min, etc.]
<In stepping motor mode>
0 to 62500 [pulse/s]
0 to 37500000 [mm/min, etc.]
Change the command speed and bias speed at start so
that the command speed is equal to or larger than the
bias speed at start.
5102
<No. of read/write data>
1 to 100
Change the setting to within the setting range and issue
a read/write request. (Refer to section 7.2)
1158 1208 1258
<Speed change request>
1: Speed change request Do not change the JOG speed during deceleration
caused by turned OFF of the JOG start signal.
New speed value
1156
1157 1206
1207 1256
1257
JOG speed limit value
48, 49 198, 199 348, 349
<New speed value or JOG speed limit
value>
<In standard mode>
0 to 1000000 [pulse/s]
0 to 600000000 [mm/min, etc.]
<In stepping motor mode>
0 to 62500 [pulse/s]
0 to 37500000 [mm/min, etc.]
[In case of speed change value, the
minimum setting is “0.”]
Change the setting to within the setting range.
1168
1169 1218
1219 1268
1269
<Manual pulse generator 1 pulse input
magnification>
1 to 100
Change the manual pulse generator 1 pulse input
magnification to within the setting range.
Manual pulse generator enable flag
1167 1217 1267
Manual pulse generator selection
29 179 329
<Manual pulse generator enable flag>
0: Operation using the manual pulse
generator is not enabled.
1: Operation using the manual pulse
generator is enabled.
<Manual pulse generator selection>
0: Manual pulse generator operation
ignored
1: Manual pulse generator connected to
axis 1 is used.
2: Manual pulse generator connected to
axis 2 is used.
3: Manual pulse generator connected to
axis 3 is used.
•
Change the manual pulse generator enable flag to
prohibition.
•
Change the manual pulse generator selection setting
to a value between 1 and 3.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com