Mitsubishi A1SD75P1-S3, Руководство пользователя

Страница: 75 / 622

4 - 2
MELSEC-A
4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
4.1 Outline of installation, wiring and maintenance
4.1.1 Installation, wiring and maintenance procedures
The outline and procedures for AD75 installation, wiring and maintenance are shown
below.
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
Refer to
section 4.5
Refer to
section 4.5
Refer to
section 4.4
Refer to
section 4.3
Refer to
section 4.3
Refer to
section 4.2
Refer to
section 4.1 Preparation
Understand the "Handling precautions" and
"Names of each part" of the module (AD75)
Installing the
module
Install the module (AD75) on the base unit.
Wiring the
module
Wire the external device connection
connector pins, and assemble the connector.
The cables used to connect the AD75 with the drive
unit, the AD75 with the machine system input (each
input/output signal), and the AD75 with the manual
pulse generator are manufactured by soldering each
signal wire onto the "external device connection
connector" enclosed with the AD75.
Connect the cable to the module (AD75)
Wire and connect the manufactured cable to AD75
after reading the precautions for wiring.
Confirming the
installation and
wiring
Carry out the single module test
Confirm that the AD75 functions properly
with the single module test.
Servicing the
module
Confirm the connection
Check the connection using the GX Configurator-AP.
Operation of the positioning system.
Carry out maintenance
Carry out maintenance as necessary.
Dispose of the AD75
When the AD75 is no longer necessary,
dispose of it with the specified methods.
*
*
*
*
*
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com